CHILLBUSTER Evening Embers Double Burner Vent Free Gas Log Set
The CHILLBUSTER features Charred and burned-through middle logs, charring on top logs and rear log.  Deep bark logs with split accents.  C5’s opposed louver, lanced port burners provide a massive bed of embers and a split rear flame on a heavy 5/8” grate.
“EASY” control designs available: Manual (Upgradeable to remote) Variable Flame Height Remote.
Millivolt Remote Ready – can be used with wired wall switch, timer or thermostat; remote ON/OFF control; or home automation system (none included).
Electronic Ignition System – no standing pilot. Variable flame height remote control with thermostat feature in the hand-held transmitter.
Two Btu options (30,000 and 40,000) for more comfort control.




Chillbuster logo
"EASY" Safety Control System

All Chillbster Vent-Free/Reduced Vent Hearth Kits utilize a standing ODS pilot, which is lighted manually by pushing in the valve knob while depressing the piezo spark igniter. 

Battery power from the receiver operates the ON/OFF functions of the "SE" and RE" systems.  The safety function is powered by a thermocouple ODS pilot, which is 
not dependent on the inconsistencies of thermopiles.  Changing batteries is much easier than replacing a thermopile.

 All EASY Control options use the same valve body. This means that "ME" models may be upgraded to either "SE" or "RE" functionality with the addition of either the SE-UP1 or RE-UP1 upgrade kits.  If you desire, you can purchase a manual control now and upgrade to remote functionality at a later date.  Conversion can be down in place (no need to send the unit back to the factory), as each EASY valve is safety seal equipped, which prevents leakage of gas when upgrading.  Conversion is easy for anyone who can read instructions.

Should a solenoid or motor drive fail, the valve can be operated as a manual control (once the solenoid or motor drive is removed) until a replacement part is obtained.  No down time!

1) Manual ("ME")
 Turn the valve knob to light the burner and to control the flame height.

2) Variable Flame Height Remote Control ("RE")
  Motor drive system that controls the ON/OFF and flame height with the hand-held remote transmitter (included).

3) Remote Ready ON/OFF Remote Control ("SE")
  Latching solenoid system that controls the ON/OFF of the burner(s) with one of five
Wireless Remote Transmitter Devices (sold separately but necessary to operate the system - see below). "SE" is not a "millivolt" system.

Transmitter Device Options - Sold separately, but needed to operate system.

SR-2R  Simple ON/OFF 
Hand-Held Remote

THR-2R  ON/OFF with
Thermostat Hand-Held Remote

TS-2R  Wireless 
Wall Thermostat

WS-2R  Wireless 
Wall Switch

WT-2R  Wireless 
Wall Timer
30-60-90 minutes

RH3  Smooth-Sided
Ceramic Log House
to protect SE and RE 
Receivers from heat